How To apply CarPro - CQuartz UK 3.0 - Ceramic coating

Written Instructions: 

  • If contamination exists it is recommended that you Iron X and clay your vehicle before polishing.
  • To gain the most from Cquartz it is recommended that your vehicle have all surfaces 100% clean and paint polished to a high level
  • Use CarPro Reflect to achieve an incredible high gloss finish in less time with no fillers
  • Use CarPro Eraser to remove all oils leftover from Reflect – This is critical to ensure durability of CQuartz
Directions: (Use only in good ambient lighting)
  1. Wrap a 4″ mf Suede around the grey side of applicator block
  2. Shake CQuartz UK
  3. Slowly open bottle and drag one line of product across applicator
  4. Spread across paint in a criss cross pattern approximately 2 sq ft at a time depending on conditions
  5. Buff off as soon as it flashes (within 1-5 minutes depending) using a CarPro No Lint Ultra Towel 16″ x 16″
  6. Be sure to remove all excess residue and only then do you move to the next section
  7. Switch out applicators regularly
  8. Apply Reload before 1 hour.  Wait until next day for Reload if you miss the 30-60 minute window
After Tips:
  • Keep surface dry for at least one hour after application (For best results keep dry 24 hours)
  • Gently wipe any water off the surface during the first 24 hours after application
  • Avoid detergents and chemicals for 5 days after application
  • If it is dry and the air is clean outside then you may park the vehicle in direct sun after application to speed the curing
Precautions:
  • Do not apply in direct sun or on hot surface
  • Do not re-use 4″ Suede applicators
  • Do not re-use the towels you used to buff off with on paint
  • Wear hand protection
  • Wear respiratory protection such as painters mask
Back to blog